How To Install A Diving Board Base
The diving boards nosotros acquit are made by Southward.R. Smith and Interfab. These two manufacturers offer a multifariousness of residential and commercial diving board options. The primary factors when considering a board is the size and the amount of leap. For safe, the manufacturer volition recommend a diving lath based on your pool size. They can help you summate the minimum "diving envelope" (h2o depth) and proper board size for your particular pool. We recommend contacting the manufacturer of the board you are considering to be certain information technology volition work with your pool.
 SR Smith epoxy kit | A complete diving board package includes a board, a base and related hardware for installation. Part of that hardware is the jig which is set in the physical of your pool deck. The base then attaches to the jig and the board is bolted to the base. Many customers want to know if they can install a board and base in their existing concrete deck. The reply is yes but this requires drilling into the deck and using a SR Smith epoxy kit. The same would hold true if you are replacing an old board and base and the original jig is non in acceptable condition to be used once again. The old bolts would be sawed flush with the deck and the new ones would have to be positioned so equally to avert the original bolts. |
Some people are looking to but replace the board and attach a new ane to their existing base. The best way to do this is to friction match the bolt pattern (see our diagram below for our Interfab boards). If this is not possible, you can purchase a board without pre-drilled holes so that you can drill the holes to match your base. However it is worth noting that these boards are not covered under warranty by the manufacturer.
Installing a Diving Board
Each residential diving board will crave a minimum surface area of deck space based on the size of the board and base. A typical minimum is a concrete pad around 8' x 4' x 6'. Diving stands take to meet with local government codes and so it's a good idea to check on this before purchasing. Manufacturers too set minimum unobstructed headroom from the meridian of the diving board.
Diving boards must be placed at deep terminate of the pool at centerline. The jig should be fix in concrete in accordance with the manufacturer's instructions. Before pouring physical around jig, check the jig commodities pattern for any misalignment that might have occurred during shipping. Refer to instructions to make sure that the bolts projection out of concrete enough and accept aplenty concrete depth beneath jig. When the finishing deck surface, it is disquisitional to maintain a level surface where the jig bolts project out. This is so that the stand up will make compatible contact with the deck when information technology's placed over the jig. Before mounting the stand, chisel away whatsoever excess concrete that may have built up around jig bolts. If at that place are bolt caps, remove them before placing the stand up over the jig bolts and secure according to manufacturer's instructions. Secure the diving board to the stand according to their instructions, making certain the tiptop surface of the diving board is level from side to side.
Manufacturers typically follow ANSI (American National Standards Found) standards for the installation of diving boards. In some cases, local lawmaking might exceed these standards so nosotros definitely recommend checking with your local government. Y'all can request a copy of the consummate ANSI standards for residential in-ground pond pools by contacting the Association of Puddle & Spa Professionals at 703-838-0083 or www.nspi.org.
Interfab Diving Boards Bolt Hole Blueprint
Go to our PoolAnswers section for Diving Board Questions
Source: https://www.inyopools.com/info_diving_board.aspx
Posted by: cannadygles1968.blogspot.com
0 Response to "How To Install A Diving Board Base"
Post a Comment